DigiPlus

List of contents of this article:

• 1, Is it illegal to stick car stickers?
• 2、How to paste car stickers< /Li>
• 3,DigiPlus How to stick car stickers and the specific steps?
• 4、 Do I need to stick a film on the whole car?

Is it illegal to stick car stickers?

The traffic police department has no way to determine whether some personalized car stickers affect driving safety, so it is difficult to investigate and deal with them.However, the traffic police department reminds: car stickers with advertising nature are not allowed to be posted. Humorous and mocking car stickers are based on the premise that they do not affect other people's driving. It is illegal for personalized car stickers to exceed 20% of the area of the car body and will be punished.

Car stickers are not illegal. As long as the area does not exceed 30%, it is allowed, and if it is pasted, it needs to be filed with the DBL. Stickers can be pasted on the car body, but the relevant regulations must be observed. Advertising car stickers are not allowed. Car stickers are based on the premise that it does not affect the driving of others.

Legal analysis: Car stickers are not illegal, and car bodies can be stickers, but relevant regulations should be followed. Advertising car stickers are not allowed. Humorous and mocking car stickers are based on the premise that they do not affect other people's driving. It is illegal for personalized car stickers to exceed 20% of the area of the car body and will be punished.

How to stick car stickers

1. Clean the car body and keep it dry. Determine the position that needs to be pasted. Under normal circumstances, slowly paste it, scrape it flat with a tool, and remove the bottom paper. If the graphics are too small, you can also tear off all the transparent transfer film and stickers before pasting. But you must be careful not to cause accidental adhesion.

2. The pasting method of car stickers is as follows: Before applying the film, first make sure that the working environment meets the requirements of dryness and less dust. Otherwise, dust debris will enter during work, which will affect the effect of the film. It is recommended to wash the car before applying the film.

3. Car film is attached to car glass to control sunlight and ensure safety. In addition to sunlight control, its basic safety performance includes clarity,Anti-glare, ultraviolet insulation, heat insulation, anti-scrature, adhesive glass fragments, sufficient shelf life and privacy protection, ensuring safe driving performance, etc. Increase the beauty.

4. Prepare the sticker, as shown in the figure below: straighten the transfer film, as shown in the figure below: tear off the base paper of the car sticker in reverse; wipe the position where you want to stick the car sticker; stick the sticker first after aligning; then push up with a towel and push it to the end.

How to stick car stickers and the specific steps?

Measure the size of the car window and cut the film according to the size. The size must be suitable. If you can't be sure, the size can be slightly larger, but never smaller. Clean the window glass. This step is very important, because if there is dirt on the glass, even a little, it will affect the effect of the film.

Steps for car film: cut the car film according to the size of the car window; wipe and clean the front and rear window glass; use a baking gun to shape the car film; finely cut the car film after the baking film is completed.

The pasting method of car stickers is as follows: Before applying the film, first ensure that the working environment is dry., these requirements are less dust, otherwise dust and debris will enter during work, which will affect the effect of film. It is recommended to wash the car before applying the film.

Prepare the sticker, as shown in the figure below: pull straight and paste the transfer film, as shown in the figure below: tear off the bottom paper of the car sticker; wipe it clean to the position where you want to stick the car sticker; stick the sticker at the end after aligning; and then push it up with a towel to the end.

Car film is applied to car glass to control sunlight and ensure safety. In addition to sunlight control, its basic safety performance includes clarity, anti-glare, ultraviolet insulation, heat insulation, anti-scrature, adhesive glass fragments, sufficient shelf life and privacy protection, ensuring safe driving performance, etc. Increase the beauty.

Do I need to stick a film on the whole car?

1. The car can be pasted all over the car, but it is not necessary to stick it all. The relevant introduction of the car film is as follows: the part where the film can be left: the glass of the driver's and co-driver's cab can be left in the part near the front of the car to prevent the film. The light insulation is too good to make it difficult to see the rearview mirror at night.

2. Of course, the film can not be applied to the whole car, but it is generally recommended to apply the film to the whole car. After all, the film has a good thermal insulation effect. As for the brand, we don't recommend it, but there are a total of 7 enterprises and 8 brands under the board members of the International Window Film Association. You can contact them first.

3. You can apply a film to the whole car and paste the invisible car jacket to the paint of the motor vehicle, which can effectively protect the paint surface of the vehicle from scratches. Pasting the glass film on the glass of the motor vehicle can play an aesthetic role and prevent ultraviolet radiation.